The side load of Festo pneumatic cylinder should not exceed its allowable value during operation. It can maintain the normal operation and service life of the pneumatic cylinder during use. Prevent moisture in the system from freezing.
When the Festo pneumatic cylinder is running slower than normal, there will be many factors for such willingness. The product needs to measure the pressure of its main system during the use process, and then check the Whether the pressure system is consistent with the initial setting.
If the Festo pneumatic cylinder is removed and not used, it is necessary to pay attention to the rust-proof surface of the product. The inlet and exhaust ports of the equipment need to be equipped with dust blocking caps. Due to the high precision of product production and guidance, please do not disassemble the pneumatic cylinder to fix it by yourself. block and pneumatic cylinder head.
Festo pneumatic cylinders belong to pneumatic components, so the answer to this question is yes, and there is no doubt about it. In addition, it should be known that the pneumatic components mainly include air source processing components, pneumatic control components, pneumatic actuators, and pneumatic auxiliary components, and the pneumatic cylinders belong to pneumatic actuators.
The Festo pneumatic cylinder system controls the position, speed and torque. The equipment needs to effectively complete its linear motion during the use process, and can effectively transform the transmission through mechanical devices such as toothed belts or screw rods, so the structure relatively complicated.
The structure and principle of Festo pneumatic cylinder are very simple. The whole equipment is very easy to install and maintain. The output force in the equipment is proportional to the square of the pneumatic cylinder diameter, so the output force of the electric pneumatic cylinder is directly related to the power of the motor, the pneumatic cylinder diameter and the pitch of the lead screw. There are relationships.
Festo pneumatic cylinders have strong applicability, the equipment can work normally in high temperature and low temperature environments, the equipment has a certain waterproof ability during use, and the equipment is very suitable for use in various harsh environments. Reason analysis and treatment method of Festo pneumatic cylinder not running
The Festo pneumatic cylinder is first used to remove the ductile flat washer (screw) at the end of the pneumatic cylinder with a circlip pliers, and remove the pneumatic cylinder piston rod. It is because the sealing ring is too damaged, so remove the sealing ring, then install a new seal kits, and then clean the pneumatic cylinder block to ensure that the two air inlets are unobstructed. All is well, scrub the inside of the drum with a small amount of crystalline unsalted butter. Install a ductile flat washer at the end of the pneumatic cylinder to increase the life of the pneumatic cylinder by 1 to 2 years.
The crawling of Festo pneumatic cylinders, generally speaking, is a phenomenon that occurs when the pneumatic cylinder pressure is restored and its thrust is greater than the fine friction force. The main reason for this is that when the pneumatic cylinder travels, its dynamic friction and static friction resistance are different, which leads to this problem. On the pneumatic cylinder, the booster valve can be used, but it still depends on the specific situation, such as whether the pneumatic cylinder can withstand it, and whether it can be easily operated and used, and whether it will bring some benefits. If there is a problem with one of them, then the booster valve cannot be used. Special pneumatic cylinders are developed on the basis of ordinary pneumatic cylinders. Specifically, it is to transform the structure of ordinary pneumatic cylinders to meet different work needs, and at the same time, to obtain some special properties or functions to reflect its particularity.
Post time: Jun-02-2022